The Processes
This is the part I was trying to replicate.
My first attempt at making the break part because apparently I can't read step by step instructions.
After I figured out what I was actually doing I first made the base.
Then, I added the second layer.
Next, I uploaded it into Fusion 360 and added the tool paths.
Finally I set up the simulator to make sure it would work.
Using the CNC Mill
Final Result
Conclusion
This project was truly a lesson in the importance of starting over. Most of my time spent on this project was redo what I had done the class before but the right way. Although frustrating, it was very humbling to have to admit that not every first try is successful. Hopefully I have gotten all of my failures out of my system and the final project goes smoothly.